Techniques for Finding Shorts in Printed Circuit Boards

After ordering a new pcb and populating all the components, sometimes you’ll find a short between two signals. This can be especially hard to track down if it’s touching a gound or power signal that travels all over the board. Worse yet, sometimes the short is on an internal layer and can’t be seen.

Common Causes:

  • A small solder bridge or ball between pins: Sometimes small strands of solder will bridge two pins–this is especially easy to do on “bard bones” boards without any solder mask. Using too much solder paste, or paste that’s past it’s prime, can also lead to bridges or small balls getting lodged behind pins. The balls are especially hard to remove since solder wick usually can’t reach them. Sometimes a thorough flooding of solder followed by more wicking will work.
  • Incorrect components / pinouts: Make sure the pinout on that spare voltage regulator you had lying around actually matches the layout connections.
  • PCB manufacturing erros: Sometimes you’ll find hair-line connections where they shouldn’t be, especially in areas close to the manufacturer’s limits.

David at uCHobby.com had some good tips for finding shorts in printed circuit boards.

    • The obvious thing to try is to start removing components and isolate sections of the board. This may also require cutting a few traces.
    • If you’ve already taken all the components off, and carefully checked over the board for obvious errors, try running a few amps through the offending traces. If it’s a hairline pcb manufacturing mistake, the small thread of conductor will burn up under the amperage. Your other traces, even ones as small as 8mils, should be fine for a short time under a few amps.
    • Lastly, if you’ve narrowed down the short but can’t see it because it’s inside the board, it might be time to drill. David had some horror stories about drilling through 10 layer boards to fix one trace while breaking traces in 7 other layers. Have some “green” or “white” wire handy to jumper the broken traces.

Any other ideas for quickly locating a short without resorting to board surgery or removing all your painstakingly placed parts?

 

Custom Stribe Duo with Joysticks, Pots

On request, we created a custom Stribe Duo with a joystick and two pots mounted on the side. If you’re interested in similar mods, let us know. We can add things like MIDI ports, VC (voltage control) inputs, etc.

Make Cheap Standoffs with Nylon Tubing

Tan Tran came up with a cheap substitute for aluminum standoffs: nylon tubing. Polyethylene does a decent job too, and can be had for under $.10 a foot at your local hardware store. The 1/4″ OD (outside diameter) stuff shown in these pics accommodates up to #8 size screws.

Mercury Tilt Switch – Old School Accelerometer

Rummaging through the ubiquitous box of random stuff, I pulled out a mercury tilt switch, which were / are used in vending machines, thermostats, and construction equipment to detect tilt. The liquid drop of mercury conducts current when it bridges two contacts at one end, and, according to wikipedia, can operate millions of cycles since there’s no wear. Anyone know the right way to dispose of these?

About

CuriousInventor launched in late 2006 (pre-arduino era!) as a place to enable hobbyists, students, and musicians to create their own technology. We sold open-source kits and tools, and offered numerous guides & videos on things like soldering, metal working, screws, electronics, and more. 

The store is now mostly empty, but we’ve kept the product pages and guides up since they have useful information. Many of our guides and videos still rank on the first page of google searches and have been seen millions of times. Content on this site and the CuriousInventor YouTube channel produced by Scott Driscoll.

Top Videos