Description
Comes with all necessary hardware, including:
- (16) 8-32 screws
- (16) 8-32 nuts
- (4) rubber feed
- (2) 4-40 standoffs
- (1) 2-56 screw (for small arduino mounting hole)
- (5) 2-56 nuts (for small arduino standoff and nut)
- (20) 4-40 .5″ screws for buttons
- (20) 20 lock washers for buttons
- (22) 4-40 nuts (for standoffs and button screws)
You’ll also need:
- arduino Diecimila
- unsped shield
- spark fun buttons and pcbs
- (64) bright LEDs (1000mcd blue LEDs shown)
- (64) small-signal diodes
- 8-Bit Shift Register. mouser: 512-MM74HC164N
- 8-Bit PISO Shift Reg, mouser: 511-M74HC165
- 10uF cap
- (3) .1uF caps
- 10 Pin Common Bus Resistor Network, mouser: 266-100K-RC
- (2) 2×8 headers
- (2) 16 pin IDC sockets
- ribbon cable
- (1)single row male headers
- 24 pos. socket, 14 pos. socket, 16 pos. socket
- MAX7721 or MAX7719
- current limiting resistor, see the forward voltage chart here
Customer Build (black version): dj_edition’s build 
Please see our blog post detailing the build process. SparkFun buttons are larger than the monome buttons. Cases and faceplates are not compatible. 
Reviews
There are no reviews yet.